Home › Services › Boiler Services in Fort Collins, CO

Boiler Services in Fort Collins, CO

Boilers heat in a different way from furnaces. Many owners will tell you they heat better. A boiler does not blow hot air. It heats water. It moves the water through baseboards, radiators, or in-floor tubing. The heat is even. It is silent. It is dust-free. There is no blower. There are no drafts. There are no vents st

Copper boiler piping with red-handled ball valves in a home boiler room

We repair, maintain, and install home boilers across Fort Collins and Larimer County. We work on aging cast-iron workhorses. We work on modern high-efficiency condensing units too.

Boiler trouble? Call (970) 387-7504 to request service, or check availability online.

A Job Like This, Start to Finish

The radiator home swap. An Old Town home with radiators ran its cast-iron boiler to the end. A new high-efficiency boiler took its place. The radiators stayed. The quiet, even heat stayed too. Boiler heat is a slow roast, not a blast furnace. That is why owners love it. Turnaround: three days. Price range: $4,000–$7,500. Scope: drain and pull the cast-iron boiler, set a new high-efficiency boiler, and keep the radiators. Materials: a new high-efficiency boiler. Size: sized in BTU to the home.

How boiler heat works (and why owners love it)

A boiler heats water to 140–180°F. A pump pushes it through a loop of baseboard units or radiators. Each room's heat comes off the loop. Thermostats control zone valves. The valves open and close sections of the loop. There is no air handler. There is no ductwork. There is almost no noise. Just steady radiant warmth.

That simplicity is the appeal. It is also the trap. Boilers have fewer parts than forced-air systems. So they run for decades. But when something does fail, it tends to be water-related. And water damage doesn't wait.

Boiler repairs we handle

  • No heat / lukewarm radiators: This is usually air trapped in the system. It needs bleeding. It can be a failed pump. It can be a stuck zone valve.
  • Leaking boiler or piping: Pinhole leaks in old piping cause this. Failed seals cause it too. A pressure relief valve can discharge. We find the source. We fix it before water does real damage.
  • Pressure problems: Boilers run at 12–15 psi cold. Psi is pounds per square inch, a measure of pressure. Pressure that keeps dropping means a leak. Pressure that keeps climbing means a tank or fill valve issue.
  • Ignition and burner issues: The basics are the same as a furnace. Ignitors, flame sensors, gas valves, and venting.
  • Noisy operation: Kettling is a rumbling from scale buildup on the heat exchanger. Air in the lines causes gurgling. A failing pump bearing can make noise too.
  • Annual service: A combustion check. A water chemistry glance. A safety valve test. A control check.

The hard water problem

This is the big Fort Collins boiler issue. Our water carries enough minerals to scale up a heat exchanger over the years. Scale coats the metal. It blocks heat from reaching the water. The boiler works harder to transfer heat. Efficiency drops. The unit starts kettling. On older boilers we descale. On new installs we discuss water treatment options. If your boiler rumbles like a kettle, scale is the likely culprit. Catching it early prevents heat exchanger damage.

Boiler installation and replacement

When a boiler is done, a swap is simple but not casual. Cracked sections end a boiler's life. A worn-out heat exchanger does too. Gas bills that sting from low efficiency are a sign as well. We size the new boiler to the radiation in the house. That means the baseboards and radiators. They set the load. Square footage is only part of the picture. We choose between standard and high-efficiency condensing models. We handle venting, piping, and controls.

Condensing boilers run at 90%+ efficiency. They need different venting than old atmospheric units. They produce condensate that must drain. Condensate is water that forms as the boiler cools exhaust gases. We handle the conversion. Zone controls get updated at the same time. Old single-zone systems can gain room-by-room control. New zone valves and thermostats make it happen. It is the single best comfort upgrade for a boiler home.

Boiler maintenance: the annual visit

Boilers need yearly care like any fuel-burning system. The visit covers a burner and ignition check. It covers a flue inspection. It covers pressure and temp checks. It covers an expansion tank check. It covers a safety relief valve test. And it covers a look at water quality. Annual service catches the slow failures. The weeping seal. The drifting pressure. It catches them before they become the flooded basement.

What This Costs in the Fort Collins Area

Every home is different. Request a quote for your exact cost.

ItemMarket rangeWhat drives the range
Boiler replacement (installed)$4,000–$7,500 (avg ~$5,750)Boiler size (BTU — the unit of heating capacity); efficiency tier (80–83% moderate vs. 90%+ high-efficiency)
  • Repair type: A zone valve or pump is routine. Heat exchanger work is major.
  • Boiler age: Sections and parts for 30-year-old units can be hard to source.
  • Water damage risk: Emergency leak calls get priority handling.
  • For replacement: Boiler size and efficiency tier matter. Standard vs. condensing matters. Venting changes and zone control upgrades matter too.

Related services: Radiant Floor Heating, Furnace Repair, Whole-Home Humidifiers

Frequently Asked Questions

How long do boilers last?
NAHB's life-expectancy study puts boilers at 13–21 years. Cast-iron models routinely run 25–35 years or more. That is longer than any forced-air gear. What ends them is usually a cracked section. A heat exchanger failure ends them too. It is not gradual wear. Annual care is what gets you to the long end.
Why are some of my radiators cold while others are hot?
It is almost always trapped air. A stuck zone valve can cause it too. Air rises to the high points. It blocks water flow. Bleeding the radiators fixes it in minutes. If bleeding doesn't help, the zone valve or pump for that loop needs attention.
What does it mean when my boiler is making a rumbling or kettling noise?
Scale buildup on the heat exchanger. Minerals from hard water coat the metal. That causes local boiling. It is common in Fort Collins water. Descaling fixes it if caught early. Left alone, it overheats and damages the exchanger.
Should I replace my old boiler with a high-efficiency condensing model?
If the old unit is failing, yes. The jump from a 70% atmospheric boiler to a 95% condensing unit is dramatic. You see it on a Fort Collins gas bill. If the old boiler is healthy, the math is less urgent. Boilers last long enough that running a working unit isn't wasteful.
Do boilers need carbon monoxide detectors nearby?
Yes. Any fuel-burning system does. Boilers are generally very safe. But a blocked flue or burner problem can produce CO like any fuel-burning gear. Put detectors on every level. Test them often.
Can I add air conditioning to a house with a boiler?
Yes. The heating and cooling systems are independent. One option is ducted AC with new ductwork. Or try ductless mini-splits. They pair beautifully with boiler heat. You get silent, even heat in winter. You get zoned cooling in summer. No ducts required.

Call (970) 387-7504 for boiler repair and installation in Fort Collins, CO. Hydronic heat, handled by people who know it.

Need Heating or Cooling Help?

Call (970) 387-7504 to request a quote or check availability. Or send the form. We will get back to you during business hours.

We serve Fort Collins and the surrounding northern Colorado communities. See our full service area.

Get a Fast Quote

Call Now (970) 387-7504Free Estimate